ErrorFindly
E929Samsung Dishwasher

Samsung Dishwasher Error E929 – Meaning, Causes & How to Fix

The appliance control system detected a condition indicating sensor calibration error – sensor values conflict with expected parameters.

Medium Severity
Low
Medium
High
Critical

Expert Verified

Reviewed by a Certified Electrical Engineer & Licensed Technician

Official Meaning

The appliance control system detected a condition indicating sensor calibration error – sensor values conflict with expected parameters.

Real-World Causes

  • 1Electronic control board failure
  • 2Faulty valve solenoid
  • 3Blocked drain pump or hose
  • 4Sensor damaged by moisture or mineral buildup
  • 5Clogged inlet filter screens

Symptoms

Look for these signs to confirm error E929 on your Samsung Dishwasher:

  • Clicking sounds as relays activate
  • Slow filling or draining
  • Error appears at start of cycle
  • Machine pauses and displays error

DIY Fix (Safe)

  1. 1Verify household water and power supply
  2. 2Inspect hoses and filters for blockages
  3. 3Restart appliance after disconnecting power for 5 minutes
  4. 4Clean accessible filters and sensors
  5. 5Run diagnostic mode if available

Professional Action Required

  1. 1Test valves, sensors, and motors with multimeter
  2. 2Inspect wiring harness and connectors
  3. 3Replace defective pumps, motors, or sensors
  4. 4Check control board relays
  5. 5Replace electronic control board if failure confirmed

Additional Context

Load Type
Any load type
Drain Related
Depends on cycle stage
Sensor Issues
Incorrect readings possible if sensors are blocked

Frequently Asked Questions

What does Samsung Dishwasher error E929 mean?
The appliance control system detected a condition indicating sensor calibration error – sensor values conflict with expected parameters.
What causes Samsung Dishwasher E929 error?
Common causes include: Electronic control board failure, Faulty valve solenoid, Blocked drain pump or hose.
How do you fix Samsung Dishwasher error E929?
Start with these DIY steps: Verify household water and power supply. Inspect hoses and filters for blockages. If the error persists, professional service may be needed.

Related Error Codes

Other Samsung Dishwasher Errors

4CWater supply error – the dishwasher is not receiving water or the fill rate is too slow
5CDrain error – the dishwasher is unable to pump water out within the expected time
LCLeak detected – the dishwasher's leak sensor in the base pan has detected the presence of water, indicating a potential leak in the system
OCOver-level water error – the dishwasher has detected that the water level inside the tub is higher than expected, indicating a fill valve that won't shut off or drain that is too slow
E413The appliance control system detected a condition indicating temperature sensor fault – thermistor readings are outside expected range
E348The appliance control system detected a condition indicating temperature sensor fault – thermistor readings are outside expected range
E31The appliance control system detected a condition indicating temperature sensor fault – thermistor readings are outside expected range
E810The appliance control system detected a condition indicating temperature sensor fault – thermistor readings are outside expected range

About the Author

Technical Review Team

Reviewed by certified appliance technicians with 10+ years of Samsung repair experience. Every error code is verified against manufacturer service manuals and real-world repair data.