ErrorFindly
E289Siemens Dishwasher

Siemens Dishwasher Error E289 – Meaning, Causes & How to Fix

The appliance control system detected a condition indicating temperature sensor fault – thermistor readings are outside expected range.

Medium Severity
Low
Medium
High
Critical

Expert Verified

Reviewed by a Certified Electrical Engineer & Licensed Technician

Official Meaning

The appliance control system detected a condition indicating temperature sensor fault – thermistor readings are outside expected range.

Real-World Causes

  • 1Loose wiring harness
  • 2Low water pressure in plumbing system
  • 3Faulty valve solenoid
  • 4Electronic control board failure
  • 5Blocked drain pump or hose

Symptoms

Look for these signs to confirm error E289 on your Siemens Dishwasher:

  • Error appears at start of cycle
  • Machine pauses and displays error
  • Appliance stops mid-cycle
  • Clicking sounds as relays activate

DIY Fix (Safe)

  1. 1Verify household water and power supply
  2. 2Inspect hoses and filters for blockages
  3. 3Restart appliance after disconnecting power for 5 minutes
  4. 4Clean accessible filters and sensors
  5. 5Run diagnostic mode if available

Professional Action Required

  1. 1Test valves, sensors, and motors with multimeter
  2. 2Inspect wiring harness and connectors
  3. 3Replace defective pumps, motors, or sensors
  4. 4Check control board relays
  5. 5Replace electronic control board if failure confirmed

Additional Context

Load Type
Any load type
Drain Related
Depends on cycle stage
Sensor Issues
Incorrect readings possible if sensors are blocked

Frequently Asked Questions

What does Siemens Dishwasher error E289 mean?
The appliance control system detected a condition indicating temperature sensor fault – thermistor readings are outside expected range.
What causes Siemens Dishwasher E289 error?
Common causes include: Loose wiring harness, Low water pressure in plumbing system, Faulty valve solenoid.
How do you fix Siemens Dishwasher error E289?
Start with these DIY steps: Verify household water and power supply. Inspect hoses and filters for blockages. If the error persists, professional service may be needed.

Related Error Codes

Other Siemens Dishwasher Errors

E263The appliance control system detected a condition indicating heater circuit fault – heating element is not operating correctly
E591The appliance control system detected a condition indicating motor control error – the controller cannot communicate with drive motor
E30The appliance control system detected a condition indicating sensor calibration error – sensor values conflict with expected parameters
E503The appliance control system detected a condition indicating drain system failure – water cannot be removed properly
E685The appliance control system detected a condition indicating temperature sensor fault – thermistor readings are outside expected range
E895The appliance control system detected a condition indicating temperature sensor fault – thermistor readings are outside expected range
E876The appliance control system detected a condition indicating temperature sensor fault – thermistor readings are outside expected range
E643The appliance control system detected a condition indicating temperature sensor fault – thermistor readings are outside expected range

About the Author

Technical Review Team

Reviewed by certified technicians with 10+ years of Siemens repair experience. Every error code is verified against manufacturer service manuals and real-world repair data.