ErrorFindly
E868Siemens Dishwasher

Siemens Dishwasher Error E868 – Meaning, Causes & How to Fix

The appliance control system detected a condition indicating drain system failure – water cannot be removed properly.

Medium Severity
Low
Medium
High
Critical

Expert Verified

Reviewed by a Certified Electrical Engineer & Licensed Technician

Official Meaning

The appliance control system detected a condition indicating drain system failure – water cannot be removed properly.

Real-World Causes

  • 1Blocked drain pump or hose
  • 2Clogged inlet filter screens
  • 3Water supply valves not fully open
  • 4Loose wiring harness
  • 5Low water pressure in plumbing system

Symptoms

Look for these signs to confirm error E868 on your Siemens Dishwasher:

  • Appliance stops mid-cycle
  • Error appears at start of cycle
  • Machine pauses and displays error
  • Clicking sounds as relays activate

DIY Fix (Safe)

  1. 1Verify household water and power supply
  2. 2Inspect hoses and filters for blockages
  3. 3Restart appliance after disconnecting power for 5 minutes
  4. 4Clean accessible filters and sensors
  5. 5Run diagnostic mode if available

Professional Action Required

  1. 1Test valves, sensors, and motors with multimeter
  2. 2Inspect wiring harness and connectors
  3. 3Replace defective pumps, motors, or sensors
  4. 4Check control board relays
  5. 5Replace electronic control board if failure confirmed

Additional Context

Load Type
Any load type
Drain Related
Depends on cycle stage
Sensor Issues
Incorrect readings possible if sensors are blocked

Frequently Asked Questions

What does Siemens Dishwasher error E868 mean?
The appliance control system detected a condition indicating drain system failure – water cannot be removed properly.
What causes Siemens Dishwasher E868 error?
Common causes include: Blocked drain pump or hose, Clogged inlet filter screens, Water supply valves not fully open.
How do you fix Siemens Dishwasher error E868?
Start with these DIY steps: Verify household water and power supply. Inspect hoses and filters for blockages. If the error persists, professional service may be needed.

Related Error Codes

Other Siemens Dishwasher Errors

E263The appliance control system detected a condition indicating heater circuit fault – heating element is not operating correctly
E591The appliance control system detected a condition indicating motor control error – the controller cannot communicate with drive motor
E30The appliance control system detected a condition indicating sensor calibration error – sensor values conflict with expected parameters
E503The appliance control system detected a condition indicating drain system failure – water cannot be removed properly
E841The appliance control system detected a condition indicating drain system failure – water cannot be removed properly
E763The appliance control system detected a condition indicating drain system failure – water cannot be removed properly
E682The appliance control system detected a condition indicating drain system failure – water cannot be removed properly
E584The appliance control system detected a condition indicating drain system failure – water cannot be removed properly

About the Author

Technical Review Team

Reviewed by certified technicians with 10+ years of Siemens repair experience. Every error code is verified against manufacturer service manuals and real-world repair data.